Will the Non-Slip Traction Tape Rolls stay put on a wet step?

That is the job — if the surface was actually clean and dry at install. Film under the adhesive is why pieces let go in a week.

Do I need a contractor?

No. Clean, dry, peel, press. If you can hang a shower caddy, you can do this.

Will it wreck the finish?

On a prepped surface it is meant to hold without eating the glaze. Peel slowly if you ever take it off.

In place, with household cleaner and a soft brush. You do not need to remove it for a normal clean.

How much does it cost?

See the current price on the product page from $31.95. Free shipping over $65 on qualifying orders.

Traction Tape

Non-Slip Traction Tape Rolls

Name: Non-Slip Traction Tape Rolls
Brand: Kahuna Grip
Price: 31.95 USD

From $31.95

Choose your options in the store to see current price and availability.

Versatile multi-purpose grip tape improves traction throughout the home. Ultra-thin, non-abrasive DIY solution for safer floors.

Waterproof adhesive
Barefoot-safe grip
Peel & stick install
Indoor & outdoor

Choose options & buy

Free shipping over $65Easy returns100% satisfaction guarantee

You'll complete checkout securely on the Kahuna Grip store.

Free US shipping over $65
DIY install in minutes
Grips when wet
Secure checkout

← Back to all products

About the Non-Slip Traction Tape Rolls

Kahuna Grip Safety, Non-Slip, Adhesive Traction Tape Rolls. Available in 2" & 4" Widths. Each roll is 30' long. This versatile multi-purpose tape can be use to improve traction in slippery conditions.

Why a wet step still wins

Factory finishes in the entry are designed to wipe clean. That same smoothness is why soap and water turn them into a lubricant. You have already felt it — the half-second where the foot goes before you do.

Suction-cup mats hide mildew and let go when the cups fill with film. Coatings wear. The useful fix is texture that stays put on a surface you actually prepped.

What the Non-Slip Traction Tape Rolls actually does

Put it where the foot lands: the tub step-in, the shower turn, the stair nose, the ramp threshold. Coverage only matters in that zone. A pretty oval in the middle of a tub you never stand in does nothing.

Match the piece to the foot

Barefoot tubs and showers want a fine texture. Outdoor steps and ramps can take a more aggressive grit. Mixing those up is how you get a complaint, not a safer house.

If you are covering a stair, the nose of the tread is the land zone. A full runner is optional. The nose is not.

How to install the Non-Slip Traction Tape Rolls

Clean until the step is honest, then peel and press. If a previous mat failed, the prep failed first.

1
The surface has to be dry and above freezing
Outdoor tape on a damp or icy step is a wasted afternoon. Wait for a dry window.
2
Scrub dust, moss, and mineral haze
Desert dust and coastal moss both act like grease under adhesive. Sweep, wash, dry.
3
Cut before you peel
Measure the strip. Round the corners with scissors so they do not lift.
4
Press hard along the whole length
A roller or the heel of your hand. Edges especially.
5
Keep traffic off until it sets
Heat and cold change cure time. A garage in January is slower than a patio in July.

Mistakes that make this fail

Sticking it to soap film
If the step still feels slick after a rinse, you are gluing to lotion. Alcohol wipe until it squeaks.
Covering the wrong zone
The middle of a tub you never stand in is decoration. The step-in, the turn, and the stair nose are the land zones.
Using outdoor grit in a shower
Coarse tape belongs on shoes and weather. Barefoot baths want a fine texture. Mixing those is uncomfortable, not safer.
Walking on it in the first hour
your area heat, cold, and humidity all change set time. Give the adhesive a quiet stretch before the next shower or the next flight of stairs.

Keeping it clean after install

Clean in place. Warm water, a soft brush, and a household cleanser. You do not peel it off for a weekly scrub. Comet or Ajax is what we tell people for the mats.

If a white haze comes back, that is mineral or soap film sitting on the texture. Clean the film. The grit is still there.

If an edge lifts, dry the area, press it back, and keep traffic off. A lifted corner that stays wet is how mildew starts — not a reason to throw the piece away on day three.